To remove folds and creases from artificial plant leaves, you can try the following methods:

1. Steam Treatment:
   • Use a handheld steamer to gently steam the leaves.
   • Hold the leaves in the steam for a few seconds, being careful not to get too close to avoid damaging the material.
   • After steaming, reshape the leaves with your hands by gently bending them in the opposite direction of the creases.
2. Hairdryer Method:
   • Use a hairdryer on a low heat setting to warm the leaves.
   • Hold the hairdryer at a distance to avoid excessive heat.
   • Once the leaves are warmed, reshape them by gently bending in the opposite direction of the folds.
3. Warm Water Soak:
   • Fill a basin or sink with warm water and a small amount of mild detergent.
   • Submerge the artificial plant in the water for a few minutes.
   • Gently shake the excess water off and reshape the leaves while they are still damp.
4. Weight Method:
   • Gently bend the leaves in the opposite direction of the creases.
   • Place the plant in a position where the leaves are held in the desired shape (e.g., use books or other objects to weigh down the leaves).
   • Leave it in this position for a period, and the leaves should gradually take on the new shape.
5. Use Fabric Softener:
   • Mix a small amount of fabric softener with water.
   • Dampen a cloth or sponge with the mixture and gently wipe the leaves.
   • Allow the leaves to air dry, and reshape them as needed.

Always test a small, inconspicuous area before applying any of these methods to ensure that the material of the artificial plant can withstand the treatment. Be gentle to avoid damaging the leaves, and exercise caution when using heat to prevent melting or warping of the artificial material.